DUMP TRAILER Electrical power UNIT-DOUBLE ACTING
This energy unit includes a energy up electrical power down circuit with load holding on both A & B ports. A stress compensatred movement handle is often added to circuit to control the decent velocity with the cylinder.
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean each of the hydraulic elements concerned prior to installation of the energy unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst, which must also be clean and absolutely free of impurities. N46 hydraulic oil is suggested.
4. The energy unit needs to be mounted horizontally.
5. Check the oil level from the tank following the original working on the power unit.
six. Oil modifying is required soon after the original one hundred operation hours, afterwards once every 3000 hrs.
DUMP TRAILER Electrical power UNIT- SINGLE ACTING
This electrical power unit has a energy up gravity down circuit. Start the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Guide override to solenoid valve could be supplied if needed. Also a stress compen sated movement control is often extra to the circuit to manage the descent speed on the cylinder.
Remark: Please seek advice from our income engineer for that different pump displacement, motor energy or tank capacity.
1. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
2. Clean all of the hydraulic components concerned ahead of set up of the electrical power unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which must also be clean and free of charge of impurities.N46 hydraulic oil is advised.
4. The energy unit ought to be mounted horizontally.
five. Check the oil degree from the tank soon after the initial operating from the electrical power unit.
six. Oil modifying is needed immediately after the first a hundred operation hours, afterwards after every single 3000 hrs.