Energy UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is developed solely for your small lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit has become widely utilized while in the field of logistic units including minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled through the solenoid valve with all the velocity managed from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Standard Description
This electrical power unit is designed exclusively to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the velocity controlled from the adjustable needle valve. When the lift rises to a higher positoin, however the electrical power supply is reduce, the decreasing movement is controlled from the manual override perform.
Power UNITS FOR LIFT TABLE 3
General Description
This power unit is intended solely for that massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the speed managed by a strain compensated movement manage valve.
Power UNITS FOR LIFT TABLE 4
Common Description
This power unit is designed exclusively for your significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the pace controlled from the adjustable needle valve. When the lift rises to a large positoin, but the electrical power supply is minimize, the lowering movement is controlled by the guide override function.
Particular Notes
one. This energy unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned before installation of the energy unit.
three. Viscosity from the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is proposed.
four. Oil altering is required following the initial 100 operation hours,afterwards once each 3000 hrs.
5. The power unit shown is made to be mounted vertically.