C and CFR Form Performance Data

C Type Flex-Flex Couplings
The C Kind coupling consists of two flex hubs, a single sleeve and a single accessory kit consisting of seals and snap rings.
CFR Variety Flex-Rigid Couplings
The CFR Variety coupling include 1 flex hub, one rigid hub, 1 sleeve, one particular accessory kit consisting of seals and snap rings.
Easy and low-cost variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in spot
Obtainable as vertical and horizontal couplings
Broad number of special variations for instance full-flex, flex-rigid mill motor
Typical configurations are available of your shelf
Ordering Facts
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Variety Couplings
Ordering Information
Puller Holes are regular on sizes four via twelve.
Puller Holes are available for sizes 7/8 by means of three.five at an extra charge.
The BSE (distance Among Shaft Ends) may perhaps fluctuate in between G and G1.
Interference bores without any set screws are standard unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, consult Engineering Segment.
Bigger sizes can be found, please consult Technical Support.


half coupling

As one of leading half coupling manufacturers, suppliers and exporters of products, We offer half coupling and many other products.

Please contact us for details.

Mail:[email protected]

Manufacturer supplier exporter of half coupling

Recent Posts