Consisting of a stress balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this power unit is made to operate material managing gear. The decreasing motion is achived by the solenoid valve together with the lowering velocity controlled by an adjustable needle valve. The left and appropriate functions are equipped having a dual pilot operated check valve and cross-over relief valves.
Remark: Please seek advice from our revenue engineer for that various pump displacement, motor electrical power or tank capability.
1. This power unit is of S3 duty cycle, i.e.,non-continuous operation,30 seconds on and 270 seconds off.
two. Clean the many hydraulic parts concerned before installation of the energy unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst, which really should also be clean and free of impurities.N46 hydraulic oil is proposed.
four. This energy unit must be mounted horizontal.
five. Check the oil degree while in the tank following the first begin of your power unit.
6. Oil modifying is needed soon after the preliminary a hundred operation hours, afterwards once every single 3000 hours.
SNOW PLOW Electrical power UNIT